|
Halltech's Killer Bee AAIS intake system is an ambient air induction system that utilizes the stock NACA
ducting from the factory to bring cool air to the filter, increasing horsepower and torque. It is easy to
install without cutting anything on your Corvette. Also, you need not be concerned about water ingestion. Off Road use Only - CARB certification is pending approval with the state of California.
NOTE: For 2006 and some early 2007 Z06, a special 5-point security TORX bit is required to remove
the MAF sensor from the stock air intake system. We offer this below for a minimal charge. This tool is not
available to the general public, and cannot be obtained at your local auto parts store. Most 2007 Z06s, and
all 2008 Z06s use the standard 6 point non-security type of TORX Bit available at any hardware or auto parts
store making this tool unnecessary for all but the 2006 and early 2007 Z06. These tools are imported from
Germany, and are made of tool steel and are very strong. 1/4" drive.
Features:
Warranty Safe
Ambient Air Induction System (AAIS) utilizes the stock NACA Ducting
Easy Installation
No Cutting or Hacking required for installation
+12 horsepower and +11 foot pounds of torque without tuning
Largest MAF Housing (103.5mm) in the industry
Video Instructions included
Smooth Bore High Temp Silicone Hose Connector
ISO 5011 Certified (99.4% efficiency) Filter
Velocity Stack Filter Flange design
1" MAF Insertion for High Flow vs. 2" stock
High Temp Color Matched Bridges Available
Application:
2006-2008 Chevrolet Corvette Z06 LS7 V8
2008 Chevrolet Corvette Coupe/Convertible LS3 V8
|
;)
){kind=spacer}
){kind=small}
