C7 Corvette Brey Krause Harness Bar

The C7 harness mount bar properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the driver's shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking. Our bars are easy to install and remove, use only existing holes and mounting points.

Note: Because of mounting locations in the C7, the b-pillar plastic sail panel covers will require slot on either side to be cut. Sail panels replacements can be ordered from your GM Dealer, part 23176134 for driver side, and part 23176135 for passenger side if you do not want to cut the original panels. Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts.

Material: Type 304, stainless steel.

Finish: Powder-coated in durable black wrinkle-finish Weight: 17.12 lbs.

Models: C7 Coupes and Z06 Coupes

Installation: Bar attaches to factory mounting points in "B" pillars.