Flush Like Taillight Kit

Click on photos to enlarge

Kit Includes Tools needed
  1. 8) spacers (6 large/2 small).
  2. 8) X-long SS screws.
  3. 4) 12" long pieces of self adhesive high density rubber foam.
  4. 4) 12" long pieces of self adhesive EPDM  rubber weather-strip.

 

 The Taillight on the left has the kit installed, the one on the right is stock.
  1. #15 Torx
  2. Cutters
  3. Philips screwdriver
  4. Scissors
  5. Cleaner ( I use rubbing alcohol )
  6. Sandpaper or file

 

Notice the 2 tabs on the ends.

The Euro lights have long pins that need to be cut off.

1: Remove taillights with #15 Torx. 2: Cut tabs off with cutters. Then sand or file smooth. The spacer will now fit flush.

 

 

 

3: Clean the taillight opening with alcohol. 4: Apply the self adhesive rubber foam tape on the bottom part of the taillight hole against the lip as shown. 5: Apply the self adhesive EPDM  rubber weather-strip next to the rubber foam.

Note: There are (2) blocks that are smaller than the other (6). Theses are used at the far ends of the outside 2 taillights.

 		  
6: Place blocks as shown and using the long SS Philips screws, install your taillights.