Join Our Newsletter
Receive the latest news on new promotions, exclusive offers, and new arrivals.
Product Description
•••••
It might just be aggressive enough to cause left-lane-no-brains to move over when they see you coming in their rear view mirror. Styled to enhance and finish off the already attractive front fascia of your 1997-2003 Grand Prix, the SD Grand Prix Front Air Dam will please even the most discerning enthusiast.
This piece slips right over your existing bumper cover with no cutting or other modifications necessary to your stock bumper. Meticulously constructed of high-pressure urethane using the finest materials available. High pressure urethane allows the part to be constructed with superior strength with a wall thickness less than half that of low pressure urethane constructed parts and provides an OEM quality product. The SD Grand Prix Front Air Dam is proudly made in the USA. The quality and craftsmanship is second to none. Comes unpainted, ready to prep and paint.
Fits 1997-2003 Grand Prix Only! Does not fit 2004 Grand Prix.
Installation Difficulty
•••••
You May Also Like
•••••
Reviews
•••••
Currently Viewing Reviews with a rating of 4. Click here to reset.
★★★★★
4.5/5 Stars out of 8 Reviews
0
0
1
2
5
Alfonso F (Grosse Pointe Park, MIchigan USA) | September 19th, 2011
Had body shop install it to make the install more professional looking. The 3M tape that comes with it is not enough! Had screws drilled in and covered and sanded prior to paint so screws weren't visible. Looks great but watch out for concrete parking spot blocks and low driveways, or you'll scrape and brake air dam.
Kyle T (Kearney, MO US) | December 27th, 2008
This product is attached via 2 sided pre-applied 3M tape. the Center pillar and the top of the sided (look for the red tape in the pic above) is all there is. I temporary attached it but, after bottoming out and highway wind vibrations I had to modify it to permanently fasten it to the car. This is when I noticed a few issues. Around the foglight the SD lip doesn't sit flush. It overhangs by about 1/4th an inch. This became a problem for me when I decided to permanently fit it and mold it into the fascia for a clean finished look. (like the red car in the above sample pic.) I also have a small gap on the passenger side that required some heat treatment to help close the gap. Overall I am pleased with with the product.
The molding quality of the part is crisp and clean with NO rough edges or burs...It is very stong and flexible. Defiantly capable of many scrapes on speed bumps and etc. Just a bit of work to go the extra mile with it...keep that in mind.
