Auto Ventshade Tailshades for Chevy Cobalt
Processing...

Auto Ventshade Tailshades for Chevy Cobalt

Item Code: CB1004
$0.00
Low Price Guarantee!
This product has been discontinued and is not available to order.

Qty

Product Description

•••••
These Tailshades come in an attractive smoke design for that stealth look. Made of smoke gray acrylic allowing the rear lights to be visible through the acrylic. Installation is easy using no tools and they are easy to remove and reinstall.
  • Made Of Durable Smoke Acrylic
  • Easily Attaches; No Tools Required For Installation
  • Limited Lifetime Warranty
  • Made In The USA
  • Installs WITHOUT Drilling

NOTE: For show, competition and off-road use only. Please check your local laws regarding any restrictions for using these covers.

APPLICATION

  • 2005-2010 Chevrolet Cobalt

Installation Difficulty

•••••
Installation Difficulty 1

Reviews

•••••
Average Customer Review 4 out of 54 out of 54 out of 54 out of 54 out of 5 3 Reviews
Write a review and share your thoughts with others.
5 out of 55 out of 55 out of 55 out of 55 out of 5 Cobalt Tailshades and my 2ยข, 5.2.2010
Reviewer: Robert S (State College, PA)
Excellent fit! Good quality product from aVs. These are uber easy to install. Completely covers taillights with no gaps near the edges of the light and bumper meeting point. Since these vehicle taillights have odd angles with the contours of the car body, this is where fitment can be tricky. Takes some patience and would recommend a dry run until you can get them to completely cover the light. Pay attention to the edge alignment, not the aVs logo. If the aVs logo is angled strange with a perfect fit, it can be removed with a plastic-friendly solvent and immediate wash/wipedown, problem solved (removed mine before installation). If you can't eyeball it, I'd suggest you get them lined up to total covered surface, tape the cover to the tail light (masking tape or painters tape) where the tailshade doesn't cover, cut the tape CAREFULLY with a razor where the shade edge ends and the taillight meets on the taillight face, remove the cover, pull the lining off the adhesive on the tailshade and reinstall permanently while realigning the cut tape edges/corners and voila! I used these to cover my LED "circle" tails to cover the side of the taillight for added effect and "upscale" appearance. The adhesive is not as visible when applied to these types of taillights upon illumination, but I can see where other taillight setups where that could be an issue.
4 out of 54 out of 54 out of 54 out of 54 out of 5 Tailshades feedback, 4.9.2010
Reviewer: Maria H (Uniontown, PA)
The tailshades were easy to install and being that my Cobalt is black, they really give it that "stealth" look that I wanted!!! The only drawback which really isn't a big one is that the manufacturer did not make them long enough on the sides and you can still see a little of the red tailight; but nothing that a little black electrical tape can't fix!
3 out of 53 out of 53 out of 53 out of 53 out of 5 Some Minor Dislikes, 4.6.2007
Reviewer: Jessica F (Corpus Christi, TX)
I just purchased this product last week. Installation is very easy, however there are some things I'm not happy with. (1) You can see the adhesive tape when your taillights are lit. (2) The tailshades aren't long enough. You can still see some of your taillight in the very back. Other than that ... They look great during the day.